Нужно подводное ружьё
Модераторы: DukeSS, KWAK, Grower
Просьба к охотникам.
Где можно купить или кто может сделать гарпунчик для мелкой рыбы.
Инструкция на английском (прислал знакомый), поэтому не видя в живую, я не разобрал, потому что ружьями никогда не пользовался. Нужна spring steel. Это какая сталь? И как это всё работает?
"The size of the shaft in the U.S. is 1/8 inch in diameter and 3 feet long. The prongs are 1/16" in diameter and 6 inches long. Sharpen one end of each prong first. I use six prongs and have them overlap the end of the spear shaft about 2 cm. Then wrap them with copper wire and braze (or solder) them in place. Then spread the prongs outward to form a cone shape with the opening about 3 cm across. Heat the other end of
the spear red hot and pound it flat so you can grind a notch in the end.
The sling for the spear is made from a round piece of wood about 4 cm in diameter and about 17 cm long. Drill a hole lengthwise through the wood exactly in the center that is a few mm larger than the spear diameter. Then attach two pieces of surgical rubber tubing about one cm in diameter and about 20 cm long, one on each side of the wood, and lash them very strongly. I cut a notch near the end of the wood all the way around so the lashing will force the tubing into the notch. Connect the free ends with a piece of strong cord about 3 to 4 mm thick and about 12 cm long. Tie a knot in each end of the cord that is larger than the inside diameter of the tubing. Force the knot into the rubber tubing 1-2 cm, then lash the tubing to squeeze the tubing as much as possible so the knots won't pull out when the rubber tubing is stretched. Put the back end of the spear through the wood and engage the notched end of the spear. Then pull back, not with a thumb and index finger, but with your whole hand grasping the back of the spear.
I forgot to add that I cut a lengthwise groove on each side the wood that is
larger inside than outside. Then I pour molten lead into each groove. This is necessary so the sling does not float".
Где можно купить или кто может сделать гарпунчик для мелкой рыбы.
Инструкция на английском (прислал знакомый), поэтому не видя в живую, я не разобрал, потому что ружьями никогда не пользовался. Нужна spring steel. Это какая сталь? И как это всё работает?
"The size of the shaft in the U.S. is 1/8 inch in diameter and 3 feet long. The prongs are 1/16" in diameter and 6 inches long. Sharpen one end of each prong first. I use six prongs and have them overlap the end of the spear shaft about 2 cm. Then wrap them with copper wire and braze (or solder) them in place. Then spread the prongs outward to form a cone shape with the opening about 3 cm across. Heat the other end of
the spear red hot and pound it flat so you can grind a notch in the end.
The sling for the spear is made from a round piece of wood about 4 cm in diameter and about 17 cm long. Drill a hole lengthwise through the wood exactly in the center that is a few mm larger than the spear diameter. Then attach two pieces of surgical rubber tubing about one cm in diameter and about 20 cm long, one on each side of the wood, and lash them very strongly. I cut a notch near the end of the wood all the way around so the lashing will force the tubing into the notch. Connect the free ends with a piece of strong cord about 3 to 4 mm thick and about 12 cm long. Tie a knot in each end of the cord that is larger than the inside diameter of the tubing. Force the knot into the rubber tubing 1-2 cm, then lash the tubing to squeeze the tubing as much as possible so the knots won't pull out when the rubber tubing is stretched. Put the back end of the spear through the wood and engage the notched end of the spear. Then pull back, not with a thumb and index finger, but with your whole hand grasping the back of the spear.
I forgot to add that I cut a lengthwise groove on each side the wood that is
larger inside than outside. Then I pour molten lead into each groove. This is necessary so the sling does not float".
Это банальный слинг (гавайское копьё) только в исполнении для пацанов..я такой делал из подручных средств своему племяннику (7 лет), по траве ползать.Сергей Б. писал(а):Просьба к охотникам.
Где можно купить или кто может сделать гарпунчик для мелкой рыбы.
"Нет ничего, что можно спрятать!"
"Учение - изучение правил; опыт - изучение исключений."
"Учение - изучение правил; опыт - изучение исключений."
Да, именно оно так и называется, гавайское копьё.
А где такое можно купить?
А где такое можно купить?
Проще сделать, чем найти...в основном это самоделки, чаще их можно было увидеть в 80-х у местных на Чёрном море, они ими удачно скарпен бьют...Сергей Б. писал(а):Да, именно оно так и называется, гавайское копьё.
А где такое можно купить?
"Нет ничего, что можно спрятать!"
"Учение - изучение правил; опыт - изучение исключений."
"Учение - изучение правил; опыт - изучение исключений."
набрать в поисковиках - изготовление гавайки" прочитать и сделать.
Course Director I A P****
обучение и подготовка инструкторов. сертификация.
****
обучение и подготовка инструкторов. сертификация.
****
Sling (Слинг), slingshot (Слингсхот) - бросание, швыряние, праща, рогатка
Может ли слинг существовать в современном мире мощных арбалетов, пневматических и гидропневматических ружей? Я думаю, что да. В арсенале охотника, он займет не последнее место. А делать ли слинг самому, или приобрести его по каталогу фирмы, это решать Вам.
http://apox.ru/weapon/gun-handmade/459- ... znakomstvo
"Нет ничего, что можно спрятать!"
"Учение - изучение правил; опыт - изучение исключений."
"Учение - изучение правил; опыт - изучение исключений."
- Lastonogiy
- Активный участник
- Сообщения: 490
- Зарегистрирован: 25-12-2007 14:48
- Откуда: H2O
- Контактная информация:
Полно мест, где можно купить:
http://www.abbiller.com/travelspear.html
http://gat-ku.com/products/fixed-head
https://www.flfreedivers.com/store/imag ... or-Web.jpg
http://www.foldspear.com/index.html
http://www.henleymarine.com/spears.html
http://www.mannypuig.com/
http://www.abbiller.com/travelspear.html
http://gat-ku.com/products/fixed-head
https://www.flfreedivers.com/store/imag ... or-Web.jpg
http://www.foldspear.com/index.html
http://www.henleymarine.com/spears.html
http://www.mannypuig.com/
Охочусь с русалками. Они на меня рыбу загоняют.
- ogr_zlodei
- Активный участник
- Сообщения: 407
- Зарегистрирован: 15-04-2007 15:42
- Откуда: Питер
- Контактная информация:
какие-то вы кислые в рассуждениях! может поднатужитесь!